Lefuneste83  Freshman Member

Thanks a lot !

Hello. I have enabled RO access on Nebula if you want to have a look at the switch settings. It is only a single Org and Site so you should find it straight away. Let me know if you need some extra information or RW access. Please take note that I have rolled back the FW version to 4.70, but the settings are unchanged from…

Hi there. Just a quick note to inform you of a very bad bug with the new firmware V4.90 on my GS1350-26HP. -Firstly it does indeed expose the port information in SNMP so this is good and it resolves the above ticket. -The big problem I am encountering is about IPV6. Since the upgrade has been applied, IPv6 packets do not…

This is great news. I'll be checking out the next Nebula release. Thanks for the help in investigating this issue.

Hello and thank you very much for your precious help. So I now understand better what to query. I have conducted the following test : snmpwalk -v2c -c [community_string] -t 3 -Cc --hexOutputLength=0 -Ih -ObentxU [device_ip] .1.3.6.1.2.1.2.2 To which I have the following reply : .1.3.6.1.2.1.2.2 = No Such Object available…

Please find enclosed the reply of the command : snmpwalk -v2c -c [community_string] -t 3 -Cc --hexOutputLength=0 -Ih -ObentxU [device_ip] .1 Let me know if you need me to try other SNMP commands against the device. Sorry but I have limited knowledge about the SNMP protocol itself.

Here is the initial SNMP log exchange from Observium As you can see, the device is properly identified but it only replies with Processor load and Availability.

Hello thank you for your quick reply. Of course SNMP is enabled in Nebula and I get full data from my several access points, as well as (this is the issue I have) very limited information about the switch itself (No port information in particular). It seems that it does not expose the MIB properly. Maybe I need to remove…

For reference here is the diagnostic ticket that I did with the Observium team