Comments
-
Thanks will give that a try. I am trying one different thing I found. I think I had to add all the options for authentication to my Network Policy. My initial tests last night were successful I will see today when users start using the wifi, but will also look at the management port.
-
Clients connecting through ethernet on VLAN10 are fine, its the ones who are tyring authenticate through the NPS server. Switch firmware: V4.70(ABMK.5) | 11/30/2021 Been searching for an update without any luck.
-
The switch is in the server room so an overview of the devices connected. Firewall connected to port 1 with all the VLANs 2 servers on VLAN 10, connected through an ethernet cable on ports 2 and 3 4 access points connected to all VLANs on ports 21 to 24 Several PCs for employees to use on VLAN 10 1 remote switch on port 45…
-
Using VLAN 10, which I never saw until you pointed it out Ping 1.1.1.1 success Ping yahoo.com Resolving yahoo.com... domain server (10.10.100.11) Resolving yahoo.com... domain server (8.8.8.8) unknown host 10.10.100.11 is an internal DNS server, set it that way for employees connecting through 802.1x.
-
I hope third time is lucky. Does the switch connect to the gateway? Yes. Firewall connects to my switch on Port 1 of the switch. Static VLAN Setup for port 1 VLAN 1 Fixed, Tx Tagging unchecked VLAN 10 Fixed, TX Tagging is checked VLAN 40 Fixed, TX Tagging is checked VLAN 60 Fixed, TX Tagging is checked VLAN Port Setup for…
-
I am not sure what is going on. I posted the answers two other times.
-
So I followed the instructions. When I went to put the port authentication (802.1x) on, I added it to the switches. That broke my switches communicating with the server. Added the port authentication (802.1x) to the APs and it disconnected them. Do I need to add MAC authentication and Guest VLAN like the document says? I…
