Comments
-
Some people use these ports as uplink ports but can be used as normal. If you use port 25 for ethernet you can't use the port 25 for SFP or the other way round
-
The NWA1123-AC-HD just has PoE+ no data cable to it It will take some days before it happens again I think the problem is with the WAX510D as managed root due to a firmware update. The setup works well when it works so I send you the setup also the setup was part of a old firmware fix in [Release Note] Access Point Series…
-
Try a rule from VLAN10 to VLAN10 on Flex500
-
Do two site to site for each subnet
-
As you only have one WAN IP it be locked to one source MAC if you do Modem <> switch <> to two devices each with a different MAC only one will work this is why you do Modem <> router <> switch This allows the router to do NAT to take a 192.168.0.xxx to your one source MAC and WAN IP out the router other types of NAT's…
-
Do you have more then one WAN on line? Do a packet capture on FLEX for the WAN and LAN and port scan the port
-
Would seem to be outbound connections not sure why you have a Wiz_HTTPS you should look in your object > service for this Wiz_HTTPS and click References to find the rule(s) it apply too. By default their are some rules that allow like LAN to any which if you don't want to allow all outbound and really lock down what is…
-
Post your Interface listings, routing and Tunnel policy rules from both sites
-
Ok I found the link to this problem if you have User-Defined Trunk using least load first Load Balancing Index(es) Outbound + inbound VLAN443 Active ge2 WAN2 Active ge3 WAN3 Active It stops DDNS on WAN2 from updating when using WRR no problem
-
here are the logs when the tunnel drops
-
what if policy control rule for destination is any? I have setup a port test on my FLEX200 not the same model as you I see if I run into any problems
-
Even if Zyxel fix the problem it may only be for current models and not EOL ones The DNS Content filter should work if you don't use dns over HTTPS
-
How many WAN IP's do you get from the modem?
-
If you have done the following You only get one WAN IP by one source MAC if you connect the switch to the Hitron many devices each with its own MAC only one may work this is why you use NAT router.