fquadt  Freshman Member

Hi @Zyxel_Kay and I guess I have to enable Link Aggregation (the DACs connect two switches)? What settings do you recommend? DAC1 XGS1930-1 ===== XGS1930-2 DAC2 Florian

Hi @Zyxel_Kay I'm afraid I've made my question unnecessarily complicated. I would like to reduce it to the bare essentials: How can I connect two XGS1930s with to two DACs? What do I have to configure in the switch settings when I want to use the last two SFP+ ports. Florian

Hi @Zyxel_Kay , I would like to stack two XGS1930 with two DACs for redundancy. Which Link Aggregation settings do you recommend (static, LACP, other settings)? Is it possible to use the last two SFP+ ports for the DAC trunk, and the other two SFP+ ports with transceivers with link aggregation and a VLAN configuration? As…

Hi @Zyxel_Melen, last weekend I tried the suggested setup. Configuring switch 1 went well but during the configuration of switch 2 I was suddenly locked out (no access to switch 2 enymore) and had to restart the switch(es) to reload the previous settings. It worked after I had changed the settings to the following (changed…

Hi @Zyxel_Melen, last weekend I tried the suggested setup. Configuring switch 1 went well but during the configuration of switch 2 I was suddenly locked out (no access to switch 2 anymore) and had to restart the switch(es) to reload the previous settings. It worked after I had changed the settings to the following (changed…

Hi Melen, thank you again for your answer. So I will summarize in the following table, what I have understood: Switch/PortVLAN1 Control & TaggingVLAN2 Control & TaggingPVIDSwitch 1 - Port 24 (Router2)Forbidden untaggedFixed untaggedPVID 2Switch 1 - Port 28 (Connection to Switch2)Normal taggedFixed taggedPVID 1Switch 1 -…

Hello Melen, thank you very much for your detailed instructions! The router2 is not VLAN-aware. I tried to follow your instructions accordingly. To make sure I made the correct settings, allow me to insert some screenshots after every step you described. Am I right that all settings have to be made in the "Static VLAN…