knebb 
Freshman Member
Comments
-
Hi, I am getting closer... * RESET all fourPLAs (yes, again) * Plugged in PLA-A and PLA-B: Got a connection between both (have not checked but I assume unencrypted) * Plugged OFF B, Plugged in C; No connection between these two at all Same for D * Plugged in B again. A and B active * Edited DOMAIN_NAME on both Connection…
-
Hi, thanks for accepting me not being dumb. However, I did as sugested:* Reset all four PLAs with the RESET button, afterwards got off the wall * Plugged in PLA-A, making sure it is connected to the LAN and is reachable by ping and web interface is working * Forced a DOMAIN_NAME on PLA-A and forced it to act as…
-
Hi,have you read my post? Did I mention page 13 there? Guys, RTFM does not help. I might misreading stuff there. In this case it will help to point me to the correct steps. It does not help telling me "read it again. And again.....". Citing page 12:You can connect a number of PLAs on a G.hn Network, but you can use the…
-
Hi, I did mention the user guide to show I know it and I read it. Unfortunately, the troubleshooting part of such guides is worthless. Just as for other companies user guides. ("LED is off? Power the device on"). However, I managed to get an encrypted connection between PLA-A and PLA-C by pressing the "Encrypt" button for…
-
Hi, Here I read I should ideally put the AP on the ceiling. Which usually means facing down. Ok, got it. But then you wrote they should not be placed on the ceiling. Or what do you mean with "outside the ceiling"? From wording I would say (not a native English speaker) an AP can be installed on the ceiling or on the wall.…
