pmuller99_

Hi, just a short update. Problem solved. Thanks. I did reset through GUI, but it didn't work well. A hardware reset did the trick. After reseting NR7101 was in bridgemode (IP Passthrough) concering WAN+LAN interface by defalut. WLAN on default Internet Group. I guess comming from a situation with an active settings to no…

Thanks No, I did not reset to default. I'll do later and report back. I'm accessing GUI through ethernet with PoE as NR7101 is position a bit far away. /Peter

Hi Ivan, Would it be possible for you to direct me where to get support on my issue. I have tried using community but with no success.

FW-version Step 1 - Enable Passthrough Step 2 - Warning / Error message Step 3 - When clicking on 'ok' ⇒ return til Step 1 Thanks for looking into my case. Br Peter

Hi Ivan, That is what I'm doing;-) But - I've described the problem in comment 55972 - If you would please take a look

Hi Ivan, Correct, I do have the generic one. Reason for my attempt to do a registration was that I would like til raise an issue to support. I want to put device in bridge mode/IP Passthrough. When reading instructions it should be possible, but when doing configuration I get an error. To correct that error I have to…

Attached is a picture on how it looks at my web interface. Is 'internet Group' menu item dependent on other settings? Regards Peter

Thanks. Issues is that last item under Network Setting is 'VLAN Group'. I'm using Chrome, so I do not expect it to be a browser issue. ?