NR7101 - Menu-entry for Interface Group is missing

pmuller99_
pmuller99_ Posts: 10
First Comment
edited January 2024 in Mobile Broadband

I want to enable IP Passthrough between WAN and LAN (not using WLAN). I get an error message say interfaces have to be in same Interface Group. In manuel a menu item 'Interface Group' exist, but in my web interface such item under Networking does not exist. I'm a bit lost then
Peter

All Replies

  • k1s
    k1s Posts: 73  Ally Member
    First Answer First Comment Friend Collector Second Anniversary

    It's here:

    image.png

  • pmuller99_
    pmuller99_ Posts: 10
    First Comment

    Thanks. Issues is that last item under Network Setting is 'VLAN Group'.

    I'm using Chrome, so I do not expect it to be a browser issue.

    ?

  • pmuller99_
    pmuller99_ Posts: 10
    First Comment

    Attached is a picture on how it looks at my web interface. Is 'internet Group' menu item dependent on other settings?

    Regards

    Peter

    image.png

  • Internetheavyuser
    Internetheavyuser Posts: 96  Ally Member
    5 Answers First Comment Friend Collector First Anniversary

    What is your FW version?

    And can you show me how you set the IP passthrough and show me the error message?

  • pmuller99_
    pmuller99_ Posts: 10
    First Comment

    FW-version

    image.png

    Step 1 - Enable Passthrough

    image.png

    Step 2 - Warning / Error message

    image.png

    Step 3 - When clicking on 'ok' ⇒ return til Step 1

    Thanks for looking into my case.

    Br Peter

  • Internetheavyuser
    Internetheavyuser Posts: 96  Ally Member
    5 Answers First Comment Friend Collector First Anniversary

    Did you reset to default when upgrade the FW? If not, please do it.

    Maintenance → backup/ restore → reset to default

    When you connect to NR7101 through GUI did you use ethernet cable connect to POE or WiFi?

  • pmuller99_
    pmuller99_ Posts: 10
    First Comment

    Thanks
    No, I did not reset to default. I'll do later and report back.
    I'm accessing GUI through ethernet with PoE as NR7101 is position a bit far away.

    /Peter

  • pmuller99_
    pmuller99_ Posts: 10
    First Comment

    Hi, just a short update. Problem solved. Thanks.

    I did reset through GUI, but it didn't work well. A hardware reset did the trick.

    After reseting NR7101 was in bridgemode (IP Passthrough) concering WAN+LAN interface by defalut. WLAN on default Internet Group.

    I guess comming from a situation with an active settings to no IP Passtrough uploading firmeware with default expected setting to be IP Passtrhough gave cause to the problem.

Categories

Consumer Product Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）