rossano  Freshman Member

In the log the AP is changing channel from 116 to 36. But I had the fixed channel on 48. Now I switched on fixed 36. I will check if this happens again. Maybe is because the 160 MHz is so wide that goes in a DFS channel?

Thank you, let me know if you need anything else.

Just happened. The Access point is doing DFS even when it's locked on the channel 48. I am sending you the diagnostic.

Thank you, when the problem will show I will inform you. The strange thing is that since I opened the discussion the problem is not showing up.

I will, but how to delete the personal information from the diagnostic?

I can't use the terminal, in the local interface is not available. But when I open the web interface I can see the current channel information. I will check when the channel is 80 MHz instead of 160 MHz.

This is now without reboot. The channel width is now 80MHz. Rebooting fixes the channel width, but after some time the channel width is back to 80MHz.

I just enabled the Support Access. The setting of 160 MHz remain the same. But the real radio signal is 80 MHz. I think that the settings change even when the auto DCS scans for the best channel.