shani

Thanks @Zyxel_Kevin, however after reset, it still didn't work, so i put the previous firmware and applied the settings to get back to where i was, Welcome to ZyWALL USG100-PLUS Username: admin Password: Router> configure[resd] Sending signal to zyshd_wd Configuration has been restored to system default. Welcome to ZyWALL…

in ZyWALL USG 100 Plus and TLS 1.2 Comment by shani May 2023

exact same issue with mine too. had to recover older firmware. any solutions?

in Zywall USG100-Plus, Where to find the Firmware, Restarting every 15 minutes Comment by shani May 2023

There is an issue with USG100-plus firmware attached here. Tried many times and everytime it fails. Had to recover the old firmware. Keep getting "/rw/compress.img bad CRC" error. anyone got solution?

in Zywall/USG Series - v3.30P9 (WK48) firmware released! Comment by shani May 2023

same problem here. The wk48 version was applied and it was stuck, had to recover. Anyone able to apply the firmware?

in ZyWALL USG 100 Plus and TLS 1.2 Comment by shani May 2023

shani

Comments