CRU_Technologies  Freshman Member

Ah OK, that has worked. Obviously that wasn't an option previously. Stable or Latest - possibly needs a better definition? Is latest a beta FW? Should Latest not be used in live environment?

That simple ey? Would of been beneficial if the error on the USG was a bit more informative than 'Computer Says No'.Thanks though.Simon.

OK thanks.I don't seem to be able to create a service range or a group?So where normally I would create a service and can put a start port and end port, I don't seem to be able to do that?

The main network on GE4, is DHCP server on the 192.168.70.x network. The Guest Wifi is successfully setup on the VLAN30 (as DHCP server) on the 10.10.10.x network. I need the secure Wifi to be on the same 192.168.70.x network. (Currently VLAN 20 - which is DHCP server) on the 192.168.110.x network. The switch setup is…

Sorry to bring this tread back to life, but it turns out that after all this time, the site hadn't used the Secure network - until now!So the main network is 192.168.70.x they can connect successfully to the Secure network and get a 192.168.110.x address, but cannot access any of the network resources.What am I…

Update: Just got off the phone with ZyXel support and it is an issue with the OPT port. Sebastian had to create Routing Policy Route to specifically send the traffic the right way. Simon.

Hi Peter, Thank you for the response. I did the exact same process on a corresponding USg310 at the same time, and didn't need to change or add any routing. Simon.

Any update?

Any update on this?

So the answer to the question is no? :anguished:

Hi,That appears to be a total Rx & Tx? Not current activity?Simon

Hi Joslyn, I have carried out the setup as described, but I can't get an IP address off either the secure or guest ssid's. Simon.

Yes that is brilliant, thanks! Can I add to the question, if the switch(s) are daisy chained, would I need to configure VLAN on the switch inter connects?