Flex200 & Nebula

CRU_Technologies
Posts: 24
Freshman Member





in Nebula
The user guide for the Flex200 seems to be in none Nebula mode.
Is there a guide for Flex200 Nebula Mode?
As 'obviously' the configuration options for direct management seem to far outway the NCC configuration options.
Can I configure it in none NCC mode, then put it back into NCC mode?
0
All Replies
-
Hi @CRU_Technologies,
You may check the NCC user guide for all Nebula features on NCC.
(Include AP, Switch, Security gateway, USG FLEX and NCC)
Since it will be updated after we release new phase for Nebula CC, you may find the link at Help > Online documents page.
For your question that move USG FLEX to Nebula, please note that USG FLEX will need to reset before doing ZTP process.
You may refer to this link for more details.
Hope it helps.Jason0 -
OK thanks.I don't seem to be able to create a service range or a group?So where normally I would create a service and can put a start port and end port, I don't seem to be able to do that?0
-
Hi @CRU_Technologies,
If you would like to configure multiple ports for security policy, you may add it in the Dst Port column directly.
Here is an example for you to reference.
Hope it helps.
Jason0
Categories
- All Categories
- 199 Beta Program
- 1.8K Nebula
- 94 Nebula Ideas
- 63 Nebula Status and Incidents
- 4.7K Security
- 236 Security Ideas
- 1.1K Switch
- 52 Switch Ideas
- 919 WirelessLAN
- 28 WLAN Ideas
- 5.4K Consumer Product
- 173 Service & License
- 296 News and Release
- 65 Security Advisories
- 14 Education Center
- 1K FAQ
- 454 Nebula FAQ
- 258 Security FAQ
- 100 Switch FAQ
- 115 WirelessLAN FAQ
- 22 Consumer Product FAQ
- 70 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 69 About Community
- 52 Security Highlight