YeK  Master Member

it seems to remove, you may ask local support for your questions

Yes, VMG3312-B10B supports VDSL2 

Hi, For configuring “repeater mode”, you can refer to user guide page33. ftp://ftp2.zyxel.com/WAP6804/user_guide/WAP6804_V1.00.pdf

Hi, "no signal" does it mean you cannot find SSID on lan client? Or you can find it, but cannot connect to VMG1312-B30B?

Hi, May I know who is your service provider and firmware version? 

Hi pdp, No, it's impossible to do that. 

Hi,Which model and firmware version you are asking?

Hi, The default username/password is admin/1234. 

Hi all, I think it's difficult to reach because router isn't assigned IP to usb port. 

Hi Paladium, Do you mean that after switching to bridge mode on the LTE3302, the LTE3302 tries to connect to the LTE network but never really successfully connects? Does the “Status” page show a WAN IP address, as the following image shows? Also, could you please take a screenshot of the LTE Modem Status page (web GUI >…

Hi, You can find it in user guide. https://www.zyxel.com/support/download_landing/product/wah7608_22.shtml?c=gb&l=en&pid=20170301200003&tab=User_s_Guide&pname=WAH7608

Hi bobale, If reset the device isn’t useful for you, you may send your device back to repair.

Hi bobale, You can try to pull the battery till it boot up and then click “Reset” button over 10 seconds. Then wait 2-3 mins, device will back to factory reset state.

Hi Kingdavid, I upgrade fw on my VMG1312-B10D from .7C0 to .8C0 and don’t have same issue as yours. What are browser and its version you use? You may try to clean cookie or find another PC/laptop to try again.

Hi Kingdavid, I did some tests, all services (http/https/telent/ping) from wan to device are no problem.You can go to Remote Management > Service control and then check “wan interface used for service” option. The default setting is “Any_WAN”, if you have specific interface for these service, you need configure it to…