Best Of

I've been playing around with ZySH recently, and for what I've seen:

It's possible to restart the LTE connection in either changing the whole status of the APN, or only the anto/manual parameter of the APN. As far as I'm concerned, switching manual to auto and revert to manual usually do the trick 99% of the time so it's probably better to modify only this small parameter instead of disabling the whole configuration, my 2 cents.

Full APN disable/enable:

• cfg cellwan_mapn edit --Index 1 --AP_Enable 0
• cfg cellwan_mapn edit --Index 1 --AP_Enable 1

Small parameter change that do the trick:

• cfg cellwan_mapn edit --Index 1 --AP_ManualAPN 0
• cfg cellwan_mapn edit --Index 1 --AP_ManualAPN 1

Moreover, it seems that the incomplete command below is suffisant to restart (reload?) the connection:

• cfg cellwan_mapn edit --Index 1

Concerning a reboot command, I've seen 2 candidates:

• sys atcr [reboot] Reset to default, erase Data partition.
• sys resetcm Do reset CM.

Unfortunatly, I really cannot afford loosing Internet this week and the comments provided in CLI (in bold above) really don't help to figure out if it will kindly reboot or will revert to factory settings 🤔. As anyone any clue about those 2 different commands?

This. My problems were solved by changing to strongest signal (another ISP).

Hai ripristinato le impostazioni di rete?

Got a response from Zyxel support with this answer:

On checking the issue with the blinking like refers to either low signal (which doesn't necessarily need low speed) or a issue with the simcard.