Comments
-
It works now on my side. BR Daniel
-
Hi all Same issue again as previously. Printscreen here:
-
Hi @Zyxel_Vic Yes exactly. All configuration work is done as in the FAQ described.
-
Hi @Zyxel_Emily To clear/empty the complete cache of the browser was the solution. Thanke You for Your help :)
-
Hi @Zyxel_Emily Thank You for Your help. Solution has worked. After one "manual Update Now", the "Auto Update" was successful.
-
Since two weeks no reboot anymore. Seams the fix is working. Thx a lot!
-
I have disabled LLDP as per advice. Will monitor it. Thank You for Your help, Dany
-
Unfortunately it is not better, reboots again
-
Hey @Zyxel_Panda Thank You for Your support. I have upgraded the FW as per your instruction. Will now monitor the success and will give feedback in 2-3 days. Regards, Daniel
-
Hi @Zyxel_KathyLin Thank You for Your help! It works this way. Fw upgrade to 540(.0)-DF-2019-05-23 proceed. Afterwards both AP's several time restarted -> LED_Suppress was allways enabled after reboot. Thank You and best regards Dany
-
Hi @IKLe Yes I hav checked the AP's configuration with PuTTY: Before reboot of the AP: Router(config)# show led_suppress status Suppress Mode Status : Enable Before reboot of the AP: Router(config)# show led_suppress status Suppress Mode Status : Disable
-
Hi @IKLeand@Zyxel_Panda In addition: I had a view into the startup-config.conf. There is allways ONLY the last changed AP's mac and status stored in. To prove I have tried the following: LED_suppress was enabled on both AP's Disable on one AP -> in startup-conf it is stored with the mac and status disabled Disable the…
-
Hi @IKLe and @Zyxel_Panda Thank You both for Your replay! I run the latest FW version on the VPN100 and the AP's WAC6502D-S: VPN100: 10.02(ABFV.0) / 2019-03-05 06:21:04 WAC6503D-S: V5.00 Patch 5 _5.10(.5) Thank You, Dany
-
Hi @Zyxel_Stanley Thank You for Your answer. So, it is as I expected not designed/possible to establish and authenticate the VPN tunnel with the same (one) device over email in combination with the FQDN. It only works with one device over the WAN IP address and http (not https, as there would be a certification proving…