Comments
-
I killed six hours today trying to connect to the board via ethernet ... no, no way ...So I'll look at the board. Bingo ! Torn off quartz resonator on the zero port of the ethernet !!! The dude who sold me the NAS apparently used a different port. there is good news1. finally everything works electrically.2 set up, learned…
-
I did it .And the firmware from the recovery flash drive went.Attached is the log from the recovery flash drive." /env/config" has changed and now the start ends - Hit any key to stop autoboot: 1booting kernel of type uimage from /dev/nand0.kernel1.bbBad Header Checksum Failed.booting kernel of type uimage from…
-
how to do it , in detail please ?
-
sorry for stupid questions - this is not my main profile at all ) I stop the autoboot - Hit any key to stop autoboot: 2usage: update -t <kernel|rootfs|barebox|bareboxenv> -d <nor|nand> [-m tftp|xmodem|ddr] [-f imagename|-a address] -cupdate tools. options -c to check the crc32 for the image and flashed one default mode is…
-
No(( maybe there is an instruction or an example? my place looks like this# boot partitionnext_bootfrom = "2"curr_bootfrom = "1"Or do you mean swap 1 and 2 ? What is the keyboard shortcut for recording? exit Ctrd+D I know this.
-
when automatically started from the second slot, the Serial port log ends at - [ 4.377343] [<8401287f>] (cpu_idle+0x77/0xa0) from [<846405eb>] (start_kernel+0x27b/0x284)[ 4.385634] [<846405eb>] (start_kernel+0x27b/0x284) from [<0400804b>] (0x400804b) this line appears after pressing the shutdown button[ 473.998934] Power…
-
... when the system automatically starts itself from slot 2, I get a normal log- "Kernel command line: console=ttyS0,115200n8, init=/etc/preinit pcie_gen1_only=yes mac_addr=,, ip=dhcp root=ubi0:rootfs ubi.mtd=2,2048 rootfstype=ubifs rw noinitrd mtdparts=spi0.…
-
Thank you Mijzelf!here is the log of his usual boot. no beeps when starting. Connected disks are shown by LEDs on. reacts to the power button - gives beeps and after pressing it activates the network port closest to the power supply. reacts to the collection button - buzzes and writes a message about it to the log. on…
