As the following scenario case: Remote site APs must support tunnel mode in order to use the captive portal. So you can use redirect on AP feature to solve such case. There are some benefits of the Redirect on AP : 1.Throughput increase (local bridge mode) Authentication packet goes back to the NXC controller Reduce the…
To set a roaming environment, APs need to use the same SSID, subnet (DHCP server), security settings and the coverage of these APs is overlapped.
The signal strength and coverage impact the station's connection. The suggestion is to make bigger power of 5GHz, and lower power of 2.4GHz. The lower 2.4GHz power can make less 2.4GHz co-channel interference and the stations will easier to connect with APs. Or, you can use the band select in SSID setting. When you enable…
There are some key points to set the captive portal: 1. The controller must be able to access the internet and do DNS query successfully. 2. The traffic must go through (comes in and goes out) the NXC controller when using redirect from controller. Note: If the traffic doesn’t go through NXC, the SSID used for connection…
Please check the QoS WMM in SSID profile is enabled or not since the QoS is disabled it could be the possibility that affects 11n station can't get more than 54 M connection rate.
When a client leaves the previous AP's network and associates with a new AP. This new AP will send a layer 2 update frame. The NXC controller judges the roaming conduction that the client goes from one AP to another should create a log “STA Roaming”. If the client disassociates from an AP, there is a short time difference…
It looks like you're new here. Sign in or register to get started.