Комментарии
-
@Cesare2 You can check the hardware temperature by debug hardware fan-get The safe value should be under 70°C
-
Please check the corresponding interface by CLI: debug system ip addrРаздел: SNMP autodiscovery leads to several interfaces, which is which? Комментарий от Zyxel_James 1 июл
-
It seems related to SNAT in the tunnel. Could you provide the subnet topology in the tunnel? where the subnets located at and what's the remote subnet from the peer side?
-
DHCP table is located below Network Status, and we implemented IP reserve feature on this page which is more convenient for configuring IP reservations. However, thanks for your feedback, I will forward this feedback to internal. Regarding hostname issue, could you check again on V1.20? I cannot see the symptom.
-
Please provide the configuration, I will check if I can reproduce this symptom
-
is it both sides behind NAT? could you provide your VPN configuration?
-
Please check on Advanced Settings, I suspect that you input the wrong information to Group Membership Attribute or something else.
-
AUTH_FAILED could be incorrect certificate or incorrect username/password, I would like to check your iOS script and VPN configuration? you may provide it via private message, thanks. BTW, could you provide complete log of the whole VPN negotiation process?
-
@ticsystems Have you ever submitted a ticket and our support pushed the WK firmware for you? if so, please provide the ticket number or device MAC, and I will check further for you, thanks.
-
Sure, please provide remote access via private message, I will look into this, thanks. Moreover, did you collect anything like console log or diaginfo after you noticed the issue?
-
Thanks for your feedback @mcdaniels Could you give an example of your request? do you mean that the email subject should add Org name so that you can sort it easily?
-
Here is my suggestion. Incoming interface: WAN1 Source IP: any External IP: WAN IP Internet IP: internal server IP You may refer to
-
The WAN1 IP is 192.168.100.168 which should not be the source IP. Source IP means that only this address-object could go through this NAT rule. If you set it as any, it means any source IP address can access it.
-
@phphil USGFLEX H series has a different platform(uOS) than ATP/USGFLEX series(ZLD). USGFLEX H series cannot set up multiple remote VPN tunnels like ATP/USGFLEX.
-
Navigate to Maintenence -> Diagnostic -> "Collect Now", it may take 3-5 minutes to collect. You can send it to me via private message, we can discuss for further checking.