SNMP autodiscovery leads to several interfaces, which is which?
JPElectron
Posts: 8
in Security
I used PRTG to do an autodiscovery of a USG Flex 500, it made several sensors but how to know which one is tied to which port? vs. interface? vs. vlan? vs. zone?
lo, which I assume was loopback and not important to me so I deleted that sensor
eth_base
eth_base1
eth1
eth2
eth3
eth4
eth5
eth6
eth7
0
Accepted Solution
-
Please check the corresponding interface by CLI: debug system ip addr
0
All Replies
-
Please check the corresponding interface by CLI: debug system ip addr
0 -
Worked great - thank you!
0
Categories
- All Categories
- 415 Beta Program
- 2.4K Nebula
- 144 Nebula Ideas
- 94 Nebula Status and Incidents
- 5.6K Security
- 237 USG FLEX H Series
- 267 Security Ideas
- 1.4K Switch
- 71 Switch Ideas
- 1.1K Wireless
- 40 Wireless Ideas
- 6.3K Consumer Product
- 247 Service & License
- 383 News and Release
- 83 Security Advisories
- 29 Education Center
- 10 [Campaign] Zyxel Network Detective
- 3.2K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 83 About Community
- 71 Security Highlight