Bob_C  Zyxel Employee

Hi Ake, The necessary settings depend on the goal you want to achieve. If you want the EX3301 getting an IP address assigned directly from the service provider, e.g. if the service provider assigns a public IP address to the NR7103, and you want the public IP address to be used by the EX3301, then you need to configure the…

Hi simo29, Endavant, Please check your message inbox. Regards, Bob

As far as I know, they don't AP mode for mesh.

Maybe you can reach out 3 UK requesting cell lock, which is useful in some cases.

Found a similar model on Amazon:

Hi Jim, In order to access your NR7101, are you able to access the NR7101 by the gateway IP address from the browser? In the following example, try to access http://10.173.244.242 or https://10.173.244.242 see if that works. C:\Users\ZT01990-04>ipconfig Windows IP Configuration Ethernet adapter : Connection-specific DNS…

Hi Hardstyle_Andi, Could you please identify which apps work and which don't when you disable/enable DoS protection? Regards, Bob

Hi Angelina, Thanks very much for the input. If you have found out the corresponding APNs for Italian service providers, could you please share them? Regards, Bob

Hi Enrico, After several discussions, I figure out how manual time setting works. When you manually configure time, it is the time of GMT+0 without daylight saving. The current time is an adjustment of manual configured time with time zone setup. For example, if I set time as 12:59, and the time zone is GMT+8, daylight…

Hi Peppino, The SBG3600-N000 has been EOLed, and unfortunately there's no record indicating which AP it supports. Regards, Bob

Hi Ayeball, Please refer to your message inbox. Regards, Bob

Hi Filip1980, What's the current firmware in your SBG3600? Thanks Regards, Bob

Hi @kantos (Laurent), Please check your message inbox. Thanks Regards, Bob

Hi, The design of the NR5101's power button is different from the LTE4506. When you press the NR5101's power button, it will sink in. Only when you press it again will it bounce back. So if the NR5101's power button is already pressed when the power outage happens, once the power supply restores, the NR5101 will boot…

Hi Jim, The design to reset data usage by date is because most of the data plan is monthly, users might need to reset the data usage counter on a specific date in a month when the usage period ends. In terms of the hour not being correctly validated, I will contact the relevant teams to handle it. Regards, Bob