-
Zyxel 8825 router remote management
Good morning, I have a Zyxel 8825 located in an uninhabited house and I need to reach it remotely as the house is far from my normal home. I enabled remote management but found that after a few days it no longer works. I had to go to the house and discovered that all I had to do was restart it and the remote management…
-
Zyxel 8825 remote management
Good morning, I have a Zyxel 8825 located in an uninhabited house and I need to reach it remotely as the house is far from my normal home. I enabled remote management but found that after a few days it no longer works. I had to go to the house and discovered that all I had to do was restart it and the remote management…
-
Zyxel 5401-b0
Hi I got this router in my home, I have internet, I can see the router on the network, but whatever I do I cant enter and configure it. This is what "error" I got, its translated from norwegian to english :P This site is not available 192.168.10.1 took too long to respond. Try this: Check the connection Check the proxy…
-
EX3301-T0 Unable to Access Internal Services from External Source
Hi, I've just had fibre broadband installed with a Zyxel EX3301-T0 router installed. How do you go about allowing access to certain ports for internal services I have set up from the outside world? I've had a look at Port Forwarding and setting up Protocols/Rules but I still can't get access to my internal services either…
-
Caller ID for Zyxel LTE5398-M904
Hi everyone, would it be possible to add a caller ID feature for the outgoing calls? On Voice / Voice Mode menu section, something that works for both 3G/2G and VoLTE calls, as a toggle button to switch on (show your number) or off (hide your numer). Thoughts? Ideas? Thanks
-
VMG1312-B10D: Using SSID Subnet makes the AP unconnectable (i.e. DHCP does not give IPs)
-
VMG1312-T20B interface grouping
Hi, I have a single WAN (PPPoE) configured on my DSL router and all it works good having the default interface group and no VLAN configured. Now I want to do some training with firewalls and I'd like to do it on a safe environment separated from the "home network". Is it possible to creare an Interface group with LAN3 and…
-
VMG3625-T50B Secondary IP
Greetings, I have a VMG3625-T50B Home router, I wanted to connect it to TP Link 480T+ load balancing router along with another ZTE router in order to have a fail safe option, technically the ZYXEL has to has the option of (Secondary IP) in order to have two subnets in order to be operated successfully by the load balancing…
-
EX3301-TO
Is there a way to get the Bandwidth data out every 30 seconds from the router? I can see it on the system monitor page, bytes sent and received. If I can get at this to an external service, or app. I can calculate data through up and down to the WAN in Mbs. I dont see any SNMP, or other network monitor protocol settings,…
-
VMG3625-T50B wireless AP schedule
Is there a way to enable disable wlan aps on a time based schedule? I need it to automatically turn off at some time of day. It doesnt exist in web interface, maybe through telnet ssh? im kind of hopeful since KEENETIC devices have such option. device: also unrelated but when you change operation mode to access point it…
-
No WiFi calling on Zyxel c3000z
I am trying to get my iPhones (one iPhone 12 and one iPhone 13) to connect to my ATT wireless via WiFi Calling. I have done all of the troubleshooting steps on the phone side of things. And, in fact, I can get both phones to do WiFi calling on a friend's Xfinity router. But when I come home, I can't get phones to connect…
-
Configure MPro Mesh
hi, I have a DX3301-T1 router and a WX3100-T0, the configuration between the two devices is ok but the devices are not connected to the mesh repeater. The signal is not extended. I ask for suggestions, thanks.
-
Can I mesh DX3301-TO and two EX3301-T0s?
Hi there. I have a DX3301 that is connected to my DSL line and is bringing broadband into my home. I have a couple of second hand EX3301 routers, and would like to mesh them with the DX3301 to defeat dead spots around the place. I've tried the MeshPro app to do it, with an EX3301 in the same room as the DX3301 but after I…
-
DX3301, any way to set up bridged and routed WAN simultaneous over one VDSL2?
Can I set up two VDSL2 WAN connections in bridged and routed more over one VDSL2 connection with DX3301 modem and then for example assign routed WAN to two ethernet ports and bridged to the rest of two ethernet port? I have done a similar setup on Telewell and on older Zyxel P-870HN-51b modem and it was working fine. I…
-
connected to modem wifi but no internet connection
So I have a vdsl2 p880 2t2r modem which works fine with a wired PPPoE connection. However, it looks like it also supports wireless WLAN, but although I can access the modem and activate wifi and connect to it successfully, I still can't get any connected device to reach the internet. So I'm wondering what settings I should…
-
Only my windows pc can't connect to wifi after factory reset
I have been using the ZyXEL VMG3625-T50B router for a while now. I haven't had any problems. For the last 2 days, my internet connection has been extremely slow. Therefore, I have tried classical solutions like rebooting the router and turning it off and on. Nothing worked and I have hit the factory reset button. After…
-
I have a problem with the upload speed
Hello, I am from Egypt. I have a Zyxel VMG3625-T50B router. I am contracted with the Internet company for a speed of 30 megabytes download. I have a strange problem inside the router. It appears to me that the private landline, the speed I have is 30 megabytes for download and 4 megabytes for upload, but when using the…
-
Where can I find latest firmware for ZYXEL VMG3927-T50K?
Where can I find latest firmware for ZYXEL VMG3927-T50K?
-
Her odaya acces point
Evimin 4 odasına Zyxel wap3205 v3 acces point kablolu bağlantı çektim. İp adreslerini değiştirdim ama hiç binin wifi si çalışmıyor. Ana PC yı açtımda bütün interne kesiliyor. Neden olabilir? Teşekkür ler
-
FMG 3005
Ich benötige eine detaillierte Beschreibung für den FMG 3005 R20 A. Muss ich zum einrichten des Gerätes etwas auf dem Gerät ändern? Mit der IP die auf der Beschreibung steht wie auch die allgemeine IP komme ich nicht aufs Gerät. Was für ein Patchkabel muss zwischen den Zyxel und dem Router? Welche der drei Typen......…
