Comments
-
I tried to reset my network setting on my iPhone, and restart the installation. then no error message ever.
-
You can check the dropbox log from the below path, it can help you to clarify the reason for this fail. tail -f /i-data/sysvol/The_Share_folder_for_Dropbox/.dropbox_log
-
I think that might be a hardware issue, and this model seems really old. You should consider to get a new Router instead.
-
You can mount it on the wall with the screw holes. but you will have to make sure the spot is able to get the signal from your Multy X before you actually mount it.
-
You can set the external port as 7000 or another port number, and set the internal port as 22, and select your Git Server. It should be work.
-
It is a bit like some attack from outside. I think you can get a firewall device, and connected it to the NAS, and run the settings to block the certain port to access.
-
If you have run some DDNS or access the NAS from WAN set, it will be possible that all the traffic head to the WAN IP. Do you access NAS from WAN? Such as, watching NAS videos or downloading files to NAS from WAN? And how do u view those data from the darkstat? do you install the darkstat on the lan device or install it in…
-
What model of your gateway? Can you set a Firewall on your gateway? If you can, please set the firewall, and stop the traffic from that IP, and also block the port 49152. Will this traffic keep happened after the firewall setting?
-
Is IP: 81.253.237.117 the WAN IP of your Modem? What is your topology? How do you connect your NAS in your Network
-
With your scenario, the new RAID 5 will keep your previous content. Just go for it, but it will take time for you to extend with 3rd HDD. However, If you don't have much data in the volume, I will recommend you to backup your data from the RAID1 and recreate a new RAID5. It can save more time.
-
@gtdaniel, Seems you already created RAID1 on four of disks, and this config cannot change the RAID type. The change type is only working on the new disk which doesn't have any volume been created with this disk. The only way to create a RAID 5 is to delete your current Volume(RAID1) and recreate a new volume. Please…
-
What model is your device? Usual, you can access the GUI of the device, and find the network mode setting to switch the NAT mode to AP mode.
-
I think you can try to connect the CAM to another SSID, and check the time again. You can enable the hotspot on your phone, and set your CAM to your hotspot SSID.
-
This problem may relate to the NTP server has blocked by your Router. What is the model of your Router? If it blocked the NTP port 123 by default, your CAM will not able to sync the time.
-
How wrong is the time? How many hours late or early? If I set the time as UTC+2, the camera time shows the time as I found on the website: https://time.is/UTC+2. Can you provide some screenshots? and compare it with the actual timing.