TAPTech  Master Member

Hi Judy, Thank you but I think I was not clear in what I wanted- I would like the option for this to work backwards. I hope my example below makes sense.

Thanks Kevin, I am glad to hear that. If my CPU usage is stuck at 99%, should I disable the Content/DNS filtering until the fix is released?

Hi Kevin, This issue has reappeared for me today and I have disabled the DNS/URL filter, and the CPU usage is greatly reduced. There is only about 25mbps of traffic flowing, and 8000 sessions when this happens. Do you have any clues as to what could cause such high CPU usage?

Looking through the logs, I found a client had connected to our network which was exceeding the 2500 session limit. Oddly enough, increasing that session limit to 3500 allowed the traffic to flow and the CPU usage went back down to about 10%. I find that behavior to be odd- wouldn't blocking the traffic use less cpu than…

Just in case there is some sort of wire, loop, strange event, etc. that might cause the switch and downstream equipment to stop functioning.

Just tagging on to this in case Toplogy Maps gets some development time. It appears that even if the "Show other devices" is toggled off, the map view is still "zoomed out" to incude them. This makes large networks have funny shaped maps.

I agree with this- I have a few large sites and keep spare Access Points (they are outdoor and get zapped by lightning on occasion) and it would be great to have them preconfigured and ready to go. It isn't a huge issue as the QR code adding does make things super easy, but at any rate, I think your proposal would be a…

Thanks for the help on this, Judy. Some other things I've noticed- if I change the VLAN setting of an NWA55AXE that is connected wirelessly, it will go offline and not reconnect. I have a test setup in my office which has a strong signal.

Thank you for the help Judy, the AP is now working 100%.

Hi Jeff, I would like the same 2FA functionality, with the ability to use the built-in Windows 10/11 client VPN and not SecuExtender VPN client. I understand if this would be a Plus/Pro licensed option.

Hi Chris, I am noticing in the MSP portal there are alert templates now. So a big part of this is complete, if I'm not mistaken. It looks nice!

Almost. I have WAN1 plugged into a fiber gateway/modem. I have 5 static public WAN IP's available. I want to route all outbound traffic from a certain internal subnet over one IP, and traffic from a different internal subnet over another IP. I could do this relatively easily with my USG60, non-nebula firewall.

Thank you James, I understand the limitation. Is there another method that you can think of, that can route traffic from a certain internal subnet over a different public static IP?

Hi James, Yes, that is the same error. I am used to my old USG60 series, where you could add a virtual interface to the existing WAN interface. What options do we have to route guest traffic over a different static IP in the same WAN interface? In this case, I have 5 static IP's available from the ISP.

As I went to take screenshots for you, I figured out the problem! When the VPN Topology feature was in Beta, I had created a VPN area. I have a third site which does not need VPN connectivity, and so I had forgotten about it. When I went into the VPN settings of that third site, even though it was disabled, it had the VPN…