monkeynia  Freshman Member

saw the question from the nebula section and tried it with this intent. i think it 's quite good to tell me to check the wifi aid and health with this type of question.

Have you tried changing the security setting on your Chrome? It looks like Chrome is blocking it.

This post might help.

Have you tried the method that Mijzelf mentioned?

Have you checked on this site? Submit a request – Zyxel Support Campus EMEA

Not sure what causes you aps offline but you can check this helpful FAQ

What profile data do you want to update?

Connected devices have automatic shutdown? Does it mean the port also links down? If it is link-down status, why do you need to turn off the status LED?

What's the device you connect with XS1930 via 10Gtek SFP+ DAC? Did you try to connect a loop on XS1930 to verify it is not working on XS1930?

@Robsonalan, What browser did you use? Maybe you can try IE mode since the GS1910 is an old switch with the old firmware. Current browsers (like Chrome or Edge) might block to access the device for some reason. And you should also check the access management setting if it enable http/https.

Did you try this path Menu > Configuration to change settings?

You can consider using the least load first. It will send new session traffic through the least utilized WAN interface, so, the VoIP traffic won't be split into two IP addresses.

You can create a VLAN, which your router does not have, to block the cameras from accessing the Internet. Or just like you said, give the cameras a bogus (or leave it blank) default gateway, so the data won't be transmitted to the Internet.

What's your purpose? Link aggregation requires using the same data transmission rate. However, the data transmission rate of port 9 is different from ports 1-8. It might be hard to fulfill your wish.

Have you checked if the PC's firewall is disabled? I have the same experience when the firewall is enabled….. By the way, you can also try to use FTP to upgrade firmware. Check this from the user guide.