-
Problem with modem on zyxel nr7101
Welcome to the forum, I have a problem with zyxel router nr7101 which is not under warranty. Exactly the problem is the modem built into it. It's not working properly for some reason - maybe it was because of the update but I don't know. As I have already changed some routers, I would like to try to fix it. Unfortunately,…
-
Quality of Service port on NR7101
Does the 7101 have (QoS), Is it possible to set the (QoS) Quality of Service to port 6050 on the 7101? We are having issues with VoIP dropping calls.
-
LTE7490-M904 Manual APN
Hi, Whenever I go to set a manual APN settings on LTE7490-M904, its says "Setting not successful. Please try again." There is no way to move off auto APN mode. I am using correct APN settings from network provider. Any reason this is not working? thank you.
-
NR2101 SSH
My NR2101 exposes an ssh port but I am not able to login with the username and password I set up. Please advise on how to connect through SSH. Zyxel Firmware versionV1.00(ABUS.4)C0Software versionRXLG1.27.00.232_0R03MiFi Software versionAXDG1.27.00.194_0R03
-
Zyxel NR7101 - Static Gateway (APN setting)
Hello. :) Does anyone know what this setting does please as I can't see it in the documention? I currently use IP Passthrough to send the WAN IP from my ISP to my Asus XT12 Mesh Node. I use fixed mode and have assigned the MAC address direct (dynamic mode works just fine but I thought I'd hard code it). What I note is…
-
NR5103e rebooting every few hours
Hi, I have had a NR5103e for a couple of weeks now and it has never managed more than 36 hours of uptime before rebooting. On average it reboots about every 12 hours. When it does so the network is only down for about 5 mins but it is frustrating nonetheless. The firmware on the router is V1.00(ACBJ.0)b10. I have turned…
-
LTE5398-M904 ipv6 passthrough
Hi, Activating ip passthrough gives the expected results for ipv4 (ip from the "home" screen is allocated to the designed mac address). However for ipv6 it's different. Whatever I do the ipv6 seen from "home" screen doesn't match the one allocated to the designed mac address. Any idea? Another question: regarding wireless…
-
LTE3301-PLUS Firmware Upgrade wants to load an old firmware
Serial number: S220Z17002405 Firmware version: V1.00(ABQU.4)C0 "Do Firmware Upgrade Now" loads an older firmware than the current.
-
Difference between NR2101-EUZNV1F vs NR2101-EU01V1F
Hello! I've found these 2 products on Amazon and they are both sold by Zyxel Networks The NR2101-EU01V1F is a bit more popular in sales than the NR2101-EUZNV1F. What is the difference?; as I can't find any
-
LTE5398-M904 - ZySH command to reboot LTE connection
Hi, i have a LTE5398-M904 router. My telephone operator schedules an IP change every 4 hours which consists of a disconnection of about 12 seconds, enough to disconnect from the vpn or from a call conference. I would like to understand if there is a way to force the reconnection of the LTE network to avoid being…
-
LTE2566-M634 SMS tav will not load
Hello, My LTE2566 will show SMS messages on the device but i cannot access the SMS application in the configuration interface. It stays stuck on the waiting message. I tried this on 4 different devices and multiple browsers on each. This happened before and i was only able to fix it by factory resetting but i do not want…
-
NR5101 5G indoor router impossible to reset !
the NR5101 5G indoor router is impossible to give a factory reset, the reset button does not function 5s/10s/15s/20s/1hour nothing works. any other options ?
-
Zyxel LTE3311-Q222 Bandwidth Management
I want to configure bandwidth settings on my router to prioritize my device but i cant find wher it is. I checked the pdf with instructions and they said its in Management>Bandwidth Management>Advanced but when i click on management it only shows UPnP
-
Zyxel LTE5388-M804
Above is working fine so far - about one week now. Tried plugging phone into the back of the router and all I get is a constant busy tone ... any ideas? Also re the antennae - external connectivity. Do I need two antennae since there are two connectors at the back of the device
-
External Antenna for LTE5388-M804
Hello I was wondering if anyone knows how to setup an external antenna for LTE5388-M804. There is no user manual for this model on Zyxel homepage for some reason, and I can't find a single mention of external antenna in the administration of the router. Is it just to plug it in and it will switch from the internal antenna…
-
LTE3301-PLUS unable to show logs
Serial number: S220Z17002405 Firmware version: V1.00(ABQU.4)C0 Unable to show logs, just getting a dialog box with a warning, the same for both types of logs. Will this be corrected in a new firmware release?
-
LTE3316 can't see SSID broadcasted & does zyxel support suck?
I recently bought a LTE3316. When i first turned it on yesterday i could not get a wifi signal from it.I thought it might've been a fluke, so i reset it, only saw the wifi for like 10 seconds before it went away. Waited a bit and reset again.This time i got a connection, i logged in and made the adjustments i needed to do,…
-
NR5101 4G doesn't work with external antenna
I just received a Zyxel Nebula NR5101 that I bought to change out my 4G router. I have the 4G router connected to a 5G antenna and get about 45mbit down and 15mbit up. I connected this new router and now get 10mbit down and 2 up. A serious disappointment. I quickly realized that the router only uses the internal antenna…
-
NR7103 2CC
2CC in NR7103, not the other units, is it maybe possible in the future?
-
Cant access Synology DDNS when using NR7101
Hello, I am having trouble accessing my Synology DDNS when using the NR7101 5g router. I have the NR7101 connected via a Unifi Dream Machine. When I open ports on my Synology the connection test fails, I have also manually opened them on the UDM. When I connect my EE broadband router to the UDM instead of the NR7101 I can…