ATP500 assign ge1 to LAN1

Options
RafaelDalben
RafaelDalben Posts: 11
First Anniversary First Comment
in Security
Hi, 

I have a ATP500 but throughout the PORT SETUP I cannot assign ge1 interface to LAN1. 

Is there a WAY to solve this ?

Thanks

All Replies

  • PeterUK
    PeterUK Posts: 2,794  Guru Member
    First Anniversary 10 Comments Friend Collector First Answer
    Options

    Go to object > zone and move ge1 out of any zone and move it to LAN1

  • RafaelDalben
    RafaelDalben Posts: 11
    First Anniversary First Comment
    Options
    BHi Peter, thx for your reply.

    But in INTERFACE / PORT / Port Group, I still can't drag the ge1 to LAN1. 


  • PeterUK
    PeterUK Posts: 2,794  Guru Member
    First Anniversary 10 Comments Friend Collector First Answer
    edited November 2021
    Options
    But if you go to object > zone can you move ge1/ge1_ppp out of say WAN/OPT?
  • RafaelDalben
    RafaelDalben Posts: 11
    First Anniversary First Comment
    Options

    Sorry, I meant drag P1 to LAN1
  • RafaelDalben
    RafaelDalben Posts: 11
    First Anniversary First Comment
    Options
    Hi,

    Yes, I did move the ge1 and ge1_ppp out of WAN and inserted into LAN...


    But I still can't drag the P1 to LAN1
  • PeterUK
    PeterUK Posts: 2,794  Guru Member
    First Anniversary 10 Comments Friend Collector First Answer
    Options

    Either its a bug or limitation


  • Zyxel_Cooldia
    Zyxel_Cooldia Posts: 1,455  Zyxel Employee
    First Anniversary 10 Comments Friend Collector First Answer
    edited November 2021
    Options
    Hi @RafaelDalben,
    ge1 interface is SFP, it's different PHY type as compared to ETH.
    That's a limitation to port grouping.

Categories

Security Highlight


Read more

Security Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）