XGS4600-32F Data abort occured

maxsaf
maxsaf Posts: 11  Freshman Member
edited April 14 in Switch
I lost inbound and outbound management access to switch during OSPF configuration process.  Now SYS led blinking continuously. Getting log using RS-232 

Data abort occured

Fault Status = 0x00000008

Fault Addr = 0xE59FF570
Current Task TCB = 0x6371AB28
Current Task Name = PINI
Current Task Stack Start = 0x6371ABE0
Current Task Stack End = 0x6372ABDE

Is there a proper way to recover switch back to working condition?

Comments

  • DogLoveSwitch
    DogLoveSwitch Posts: 6  Freshman Member
    It seems there is a problem on switch. 
    What was the last action you did before finding these message? 

  • maxsaf
    maxsaf Posts: 11  Freshman Member
    I did change OSPF area ID and click Apply
  • Zyxel_Ryan
    Zyxel_Ryan Posts: 66  Zyxel Employee
    Hi @maxsaf

    It looks that there is some error happening on your switch. 
    Could you PM me your configuration directly and let us to find some clues? 

    Ryan

  • maxsaf
    maxsaf Posts: 11  Freshman Member
    I could but i don`t have backup config. Is there any way to get current config in that condition? I don't have management access, Rs232 only. Switch continuously rebooting. 
  • Zyxel_Ryan
    Zyxel_Ryan Posts: 66  Zyxel Employee
    Hi @maxsaf

    I will PM you for some detailed information about how to recover your switch.

    Ryan
  • Zyxel_Ryan
    Zyxel_Ryan Posts: 66  Zyxel Employee
    Hi @maxsaf

    As the discussion, due to you have recovered device before we collect enough information, we are not able to find the root cause in time. If it happens next time, we will try to find the problem out.

    Ryan