[Release Note] Nebula Security Gateway Series - Phase 4 firmware has been released!

Nebula Moderator
Posts: 124
Zyxel Employee

Zyxel Nebula Security Gateway Series
Release Note
June, 2018
Firmware Version on all models
Zyxel NSG50 - V1.25(ABHP.0)
Zyxel NSG100 - V1.25(ABEA.0)
Zyxel NSG200 - V1.25(ABLD.0)
New Feature and Enhancements
- Add WAN interface connectivity check feature.
- Add Policy Route feature.
- Add Anti-Virus feature.
- Add Content Filtering feature.
- Add VPN failover feature.
- Add VPN tunnel traffic usage stats
- Enhance bandwidth management with destination network information and priority.
- Add Traffic Log setting in device local GUI for USB storage.
- Add new category (Anti-Virus, Content Filter, L2TP over IPSec, connectivity Check) to Event Log.
Notes
- To all users when upgrading Nebula devices, please make sure your device is connected to the control center and internet.
- During the upgrade process (notice the LED will flash in red rapidly), make sure the power is not inturruped or disabled, in the unlikely event of this happening, you may have to perform the upgrade again.
Nebula Forum Moderator
0
Comments
-
Hi.
Is it possible to use Content filter on a single vlan only, or will all lans be affected when enabled?0
Categories
- 6.9K All Categories
- 2 Education Center
- 1.4K Nebula
- 34 Nebula Ideas
- 40 Nebula Status and Incidents
- 3.9K Security
- 203 Security Ideas
- 748 Switch
- 31 Switch Ideas
- 627 WirelessLAN
- 9 WLAN Ideas
- 4.6K Consumer Product
- 104 Service & License
- 223 News and Release
- 39 Security Advisories
- 520 FAQ
- 238 Nebula FAQ
- 120 Security FAQ
- 73 Switch FAQ
- 67 WirelessLAN FAQ
- 6 Consumer Product FAQ
- Documents
- 30 Nebula Monthly Express
- 44 About Community
- 31 Security Highlight