Port going up and down, and cpu utilization over 100
Hello,
I think I might have misconfigured something.
I have a switch giving me those messages.
the model is an eight port
GS1920-8HP
with firmware
V4.70(ABKZ.5)
NO stp: STP topology changes
IN system: CPU utilization is over 100 and keep 5 seconds, driver count = 115.IN system: CPU utilization is over 100 and keep 5 seconds, driver count = 224.
DE interface: Port 7 - link up 100M/F
DE interface: Port 7 - link down
DE interface: Port 7 - link up 1G/F
DE interface: Port 7 - link down
DE interface: Port 7 - link up 1G/F
DE interface: Port 7 - link down
DE interface: Port 7 - link up 1G/F
Is this common for a semi default switch?
Thanks.
0
All Replies
-
Any loop between this switch and another one?
0 -
@Hoygen83,
May I know if the issue still persists? Based on the logs, there is a topology change occurs, more likely there is a ring topology in the environment which may cause a loop if there is a misconfiguration. The easy way is to check the SW port LED in the front panel and see if a port is blinking fast. Or you may enable the loop guard feature for access ports [PC] and enable spanning-tree for connected switches.
Chris
0
Categories
- 6.8K All Categories
- 1.4K Nebula
- 29 Nebula Ideas
- 38 Nebula Status and Incidents
- 3.9K Security
- 200 Security Ideas
- 723 Switch
- 30 Switch Ideas
- 602 WirelessLAN
- 8 WLAN Ideas
- 4.5K Consumer Product
- 98 Service & License
- 214 New and Release
- 38 Security Advisories
- 513 FAQ
- 236 Nebula FAQ
- 117 Security FAQ
- 74 Switch FAQ
- 65 WirelessLAN FAQ
- 5 Consumer Product FAQ
- Documents
- 30 Nebula Monthly Express
- 43 About Community
- 31 Security Highlight