ZYXEL USG FLEX 100W Log Display Options

Lost1

I don't know when this changed but when looking at my logs, they used to contain IP addresses.  When the log is emailed to me, the IP address are there. 

What setting or filter would stop me from seeing IP address information while looking at my log?

Hope this makes sense

Zyxel_James

Hello @Lost1,

Please make sure the options of source and destination are ticked, thanks.

James

mMontana

Not that much.
There were IP addresses in your emailed log and now there are no more?
There were not IP addresses in your emailed log and now there are?
Pick one of the two...

Lost1

Here is my question again,

I don't know when this changed but when looking at my logs (From the Flex 100), they used to contain IP addresses.  When the log is emailed to me, the IP address are there.

So what I'm trying to say is that when I'm viewing the log, while logged into the FW the logs do NOT show IPs anymore.  The only way I see the email address is after the log is sent to my email.

Sorry if it was not clear....it was still early  

I didn't see anything in the filter that would prevent me from seeing the IP, it's just odd that they are there after it is emailed.

Thanks!

Zyxel_James

Hello @Lost1,

Please make sure the options of source and destination are ticked, thanks.

James

Lost1

I did have those checked.....turns out I just had to shrink my page view and spread out the collums.  It was there, it was just not visible due to my view settings!

Thanks!  I should have caught that myself!