usg flex 200 firewall problem

Options
kennethc
kennethc Posts: 1 image  Freshman Member
First Anniversary
in Security

failover not working if wan1 is connected there were no internet connection. By the way wan2 is connected.

Accepted Solution

All Replies

  • PeterUK
    PeterUK Posts: 4,418 image  Guru Member
    250 Answers 2500 Comments Friend Collector Eighth Anniversary
    edited April 2023

    You can setup routing rules with ping check with NAT of a LAN to WAN1 and another rule LAN to WAN2, want ping fails on WAN1 IP the route is disabled and goes to the next rule.

  • Zyxel_Jeff
    Zyxel_Jeff Posts: 1,368 image  Zyxel Employee
    100 Answers 500 Comments Friend Collector Fifth Anniversary
    Answer ✓

    Hi @kennethc

    Welcome to the Zyxel community. Please refer to this video to configure WAN Failover via Trunk feature on your USG Flex 200. Thanks.

    https://www.youtube.com/watch?v=jogTfujoHkI

Categories

Security Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）