2.4G and 5G leds remain amber on my Zyxel nwa1123-ac pro even after correct configuration

Adrian

Hi, so I've configured my zyxel nwa1123-ac pro and it works just fine, absolutely no problem 'till now. Only thing is, the 2.4G led and the 5G led remain amber(instead of green) and I don't understand why, since it works. 
I know it might seem trivial, but I would like to know if maybe I've missed something. 
Thanks

Zyxel_Joslyn

Hi @Adrian

The LED showed Amber means the antenna switch is set to "Wall" for the radio.
Would you like to check for your antenna setting?
Physical setting.

Software setting.

The antenna switch in the web configuration has priority over the physical antenna switch after you Enable Software Control as the software setting.
Thanks.

Joslyn

Zyxel_Joslyn

Hi @Adrian

The LED showed Amber means the antenna switch is set to "Wall" for the radio.
Would you like to check for your antenna setting?
Physical setting.

Software setting.

The antenna switch in the web configuration has priority over the physical antenna switch after you Enable Software Control as the software setting.
Thanks.

Joslyn

Adrian

Yes, that was it. Thank you very much!