GS1910 Factory Reset no User/IP Management
Hello,
i bought a second hand GS-1910 switch. The switch runs firmware 2.00.
I can access the webinterface with the brwoser and login with "admin" and "1234".
After I logged in the first time, there were no "IP" button in the system category. And no "User" butten in the Security → Switch category. In this category only the "RMON" button is visible.
I set back the switch to Factory Defaults with Putty, but the problem persits.
Did anyone have an comparable problem and can guide me to a solution?
All Replies
-
I have to specify my problem:
It is not possible to make any changes to the webinterface. It seems the interface is in a "read only mode". Only the Maintenence part is working with reset and change the used firmware. But every other point in the menu is not showing any changeable setting.
0 -
Did you try this path Menu > Configuration to change settings?
0
Categories
- All Categories
- 398 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 83 Nebula Status and Incidents
- 5.2K Security
- 99 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 923 WirelessLAN
- 35 WLAN Ideas
- 5.9K Consumer Product
- 212 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2.1K FAQ
- 1K Nebula FAQ
- 445 Security FAQ
- 238 Switch FAQ
- 213 WirelessLAN FAQ
- 47 Consumer Product FAQ
- 142 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight