Can I have full configuration control on Nebula Switch using the CLI?
Zyxel_Adam
Posts: 429 
Freshman Member
Freshman Member
in Other Topics
Starting from firmware version 4.90 and onwards, Nebula Switches support full configuration adjustments via the Command Line Interface (CLI), offering comprehensive control over switch settings directly through commands.
However, any changes made through the CLI can cause inconsistencies between the local Web GUI and the Nebula Control Center (NCC). In some cases, these changes might even lead to the device disconnecting from Nebula. To mitigate risks, it is highly recommended to back up the running configuration before making any adjustments through the Web GUI. This ensures that you can restore to a previous state if needed.
Adam
0
Categories
- All Categories
- 439 Beta Program
- 2.7K Nebula
- 191 Nebula Ideas
- 121 Nebula Status and Incidents
- 6.2K Security
- 468 USG FLEX H Series
- 308 Security Ideas
- 1.6K Switch
- 82 Switch Ideas
- 1.3K Wireless
- 44 Wireless Ideas
- 6.8K Consumer Product
- 281 Service & License
- 441 News and Release
- 88 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4.3K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 93 Security Highlight