need interface rate limiting

PeterUK

Not yet tested BWM but to really test this interface rate limiting is needed.

Also be able to limit by Mb and Kb

Thanks

Zyxel_Jeff

Hi @PeterUK

OK, thank you😉. We are investigating this issue for you. Once we resolve it, you can continue testing the Bandwidth Management (BWM) feature.

https://community.zyxel.com/en/discussion/22260/modifying-bwm-rule-lockup

PeterUK

This plus I want to rate limit a bridge in and out interfaces too

Zyxel_Jeff

OK, got it. Thanks.

PeterUK

also currently not able to rate limit bridge traffic

PeterUK

When might we see rate limiting interfaces and rate limiting of the bridge interfaces (not the bridge itself but the interfaces for the bridge) please?

 

PeterUK

With the new UI for bridge will there be a added Egress rate limiting like this with BWM?

old models can Egress rate limit interfaces in a bridge so I'm hoping the same for FLEX H

Thanks

Zyxel_Judy

Hi @PeterUK ,

Could you share which specific ZLD model supports Egress rate limiting on individual interfaces within a bridge?
In my experience with ZLD devices, rate limits are applied to the entire bridge rather than to individual interfaces within the bridge.

Are you asking for H series devices support rate limiting for bridge or individual interfaces within a bridge?

PeterUK

Hi Judy

So on old ZLD like on VPN300 I have Ge1 (WAN1) and Ge8 (DMZ) that are in a bridge br1 I set Egress rate limiting per each interface like so.

Due to V1.31 UI changes per interfaces in the bridge only show in the bridge but I would like to be able to rate limit total limit going out the interfaces in the bridge. Just checking this will be possible in the upcoming firmware.

Thanks

Note: about the old ZLD the rate limiting of interface in a bridge must 1st be removed from the bridge set rate limit then add back to bridge