Usg Flex 200 - Failover with trunk
Options
Hello,
I set up a failover using trunk as explained in the tutorials.
It works fine when I test by physically unplugging the wan1 ethernet port (2)
But if I only disconnect the cable side of the cable modem, the failover on wan2 stops after a few seconds, and the only difference I see in the log is an entry msg="a connection timeout occured" cat="Myzyxel Dot Com" .
Any idea ?
0
Accepted Solution
-
8.8.8.8 in the connectivity check solves the problem…
0
All Replies
-
8.8.8.8 in the connectivity check solves the problem…
0
Categories
- All Categories
- 435 Beta Program
- 2.7K Nebula
- 175 Nebula Ideas
- 117 Nebula Status and Incidents
- 6.1K Security
- 422 USG FLEX H Series
- 297 Security Ideas
- 1.6K Switch
- 78 Switch Ideas
- 1.2K Wireless
- 44 Wireless Ideas
- 6.7K Consumer Product
- 272 Service & License
- 418 News and Release
- 88 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4.2K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 83 About Community
- 89 Security Highlight