How do I change standby firmware boot-option

Options
bbp
bbp Posts: 27  Freshman Member
First Anniversary 10 Comments Friend Collector First Answer

USG Flex 200H - Firmware 1.20(ABWV.2)

1.) How do I change standby firmware boot-option from 0 to 1?
boot-option - Show boot-option, which is used to reboot machine when
backup firmware upgrade successfully. 0:reboot, 1:not
reboot.
There's nothing in CLI Reference Guide for 1.20 firmware on how to change boot-option.

2.) How do I boot into standby firmware?
Also nothing in CLI Reference Guide for 1.20 firmware on how to boot into standby firmware.

Accepted Solution

  • PeterUK
    PeterUK Posts: 2,988  Guru Member
    Community MVP First Anniversary 10 Comments Friend Collector
    edited June 23 Answer ✓
    Options

    its

    cmd firmware boot-number 1
    cmd firmware boot-number 2
    

All Replies

  • PeterUK
    PeterUK Posts: 2,988  Guru Member
    Community MVP First Anniversary 10 Comments Friend Collector
    edited June 23 Answer ✓
    Options

    its

    cmd firmware boot-number 1
    cmd firmware boot-number 2
    

  • bbp
    bbp Posts: 27  Freshman Member
    First Anniversary 10 Comments Friend Collector First Answer
    Options

    Thank you Peter. That works.

    Answer to my question number one is similar: cmd firmware boot-option 1