Urgent FTP from internal to FQDN
Options

IntelliSoft
Posts: 5
Freshman Member


Hey
I have a USG110
It is bound to an DynDns account.
I have created a policy control, which goes from "any" to "LAN1", Destination = IP of FTP Server, Service = FTP
When I am out of my office I can connect without any problem to my FTP by using the FQDN.
But when I am in my office and have an internal IP, then I can't connect to the FTP by using the FQDN anymore.
How can I get this working? - THX a lot in advance
I have a USG110
It is bound to an DynDns account.
I have created a policy control, which goes from "any" to "LAN1", Destination = IP of FTP Server, Service = FTP
When I am out of my office I can connect without any problem to my FTP by using the FQDN.
But when I am in my office and have an internal IP, then I can't connect to the FTP by using the FQDN anymore.
How can I get this working? - THX a lot in advance
0
Accepted Solution
-
Found the solution. - I have had to enable the NAT Loopback. - Then it works fine - THX0
All Replies
-
Found the solution. - I have had to enable the NAT Loopback. - Then it works fine - THX0
-
0
Categories
- All Categories
- 434 Beta Program
- 2.7K Nebula
- 174 Nebula Ideas
- 117 Nebula Status and Incidents
- 6.1K Security
- 418 USG FLEX H Series
- 297 Security Ideas
- 1.6K Switch
- 78 Switch Ideas
- 1.2K Wireless
- 43 Wireless Ideas
- 6.7K Consumer Product
- 269 Service & License
- 416 News and Release
- 87 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4.1K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 83 About Community
- 87 Security Highlight