XMG1915-10EP - POE / PD is interrupted when booting
Hi, I have noticed, that switch when booting is performing 2 or 3 restarts of POE (power delivery is interrupted and resumed).
I would like to ask - is there any way to avoid such a situation? This is unfortunately causing that some of my SBCs etc. devices are powered up and forcibly powered off, then powered up, and again…
Of course this may lead to data loss etc. or some problem with hardware itself.
If currently it is not possible - then maybe some feature request - "delay power on after boot". I mean - option that POE is enabled only when switch is 100% booted-up.
Please consider and thank you.
regards,
Marcin
Best Answers
-
Hi @mparka,
We have found a solution for this issue, which will be fixed in the next firmware release. The ETA is the end of December.
0 -
Thank you very much.
0
All Replies
-
Hi @mparka,
I understand your concern about the power interruptions during the XMG1915-10EP boot process. I'm checking with our team if there is a solution and I will keep you posted.
1 -
Thank you @Zyxel_Melen - I will wait for a solution/suggestion if any appears from Zyxel team.
0 -
Hi @mparka,
We have found a solution for this issue, which will be fixed in the next firmware release. The ETA is the end of December.
0 -
Thank you very much.
0
Categories
- All Categories
- 414 Beta Program
- 2.3K Nebula
- 134 Nebula Ideas
- 92 Nebula Status and Incidents
- 5.5K Security
- 190 USG FLEX H Series
- 262 Security Ideas
- 1.4K Switch
- 71 Switch Ideas
- 1K Wireless
- 40 Wireless Ideas
- 6.2K Consumer Product
- 238 Service & License
- 376 News and Release
- 80 Security Advisories
- 24 Education Center
- 5 [Campaign] Zyxel Network Detective
- 3K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 80 About Community
- 70 Security Highlight