USG Flex 200 internet issue

Meszike
Meszike Posts: 6  Freshman Member
First Comment
in Security

Hello!

Internet issue. In the case of WAN1 internet, some websites do not load, but when I switch the device to WAN2 (policy route), the page loads immediately. What could be the reason for this? The content filter is turned off.

Balázs

All Replies

  • PeterUK
    PeterUK Posts: 3,645  Guru Member
    100 Answers 2500 Comments Friend Collector Seventh Anniversary

    I take it you have different ISP for WAN1 and WAN2?

  • Meszike
    Meszike Posts: 6  Freshman Member
    First Comment

    Yes. If plug in direct WAN1 cable modem a laptop, the webpages opening.

  • PeterUK
    PeterUK Posts: 3,645  Guru Member
    100 Answers 2500 Comments Friend Collector Seventh Anniversary
    edited October 2024

    Are the WAN IP's like 192.168.0.2 or are they public IP's ?

  • Meszike
    Meszike Posts: 6  Freshman Member
    First Comment

    WAN1 public ip (Vodafone Cable), WAN2_PPP: public ip (VDSL)

  • PeterUK
    PeterUK Posts: 3,645  Guru Member
    100 Answers 2500 Comments Friend Collector Seventh Anniversary

    So your Vodafone Cable is set to modem mode or bridge mode?

  • Meszike
    Meszike Posts: 6  Freshman Member
    First Comment

    Yes, bridge mode.

  • PeterUK
    PeterUK Posts: 3,645  Guru Member
    100 Answers 2500 Comments Friend Collector Seventh Anniversary

    Can you test that ISP on WAN2 port?

  • Meszike
    Meszike Posts: 6  Freshman Member
    First Comment

    WAN1 to WAN2 and WAN2 to WAN1?

  • PeterUK
    PeterUK Posts: 3,645  Guru Member
    100 Answers 2500 Comments Friend Collector Seventh Anniversary

    Yes just to rule out a bad port on the Flex

Categories

Security Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）