Why does traffic from the management VLAN always appear when a PC is connected to switch ports?
Options

Zyxel_Chris
Posts: 739
Guru Member





Nebula Switches (in cloud mode) have a built-in mechanism to prevent them from going offline when uplink ports are changed. By default, the management VLAN is applied to all switch ports.
To adjust this behavior, navigate to Configure > Switches > Switch ports on the NCC. Check the settings to see if the switch ports are assigned to the management VLAN.
To disable this, set Management control to "Disabled" to ensure the switch no longer adds this port as a member of the management VLAN.
Set Management control to "Disabled" so that your switch will no longer assign this port as a member of the management VLAN.
0
Categories
- All Categories
- 439 Beta Program
- 2.8K Nebula
- 196 Nebula Ideas
- 123 Nebula Status and Incidents
- 6.3K Security
- 481 USG FLEX H Series
- 313 Security Ideas
- 1.6K Switch
- 83 Switch Ideas
- 1.3K Wireless
- 46 Wireless Ideas
- 6.8K Consumer Product
- 284 Service & License
- 450 News and Release
- 88 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4.3K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 93 Security Highlight