DHCP and Secondary IP






It CAN be possible older models do it!
when you do a routing rule
incoming LAN
next hop WAN 2
SNAT outgoing-interface which will be the the DHCP IP
Or in my setup also
incoming WAN to Secondary IP 192.168.254.1
Source Address 192.168.252.0/23
next hop WAN 2
SNAT outgoing-interface which will be the the DHCP IP
with Static route
192.168.252.0 255.255.254.0 gateway 192.168.254.2
Comments
-
Hi @PeterUK ,
To better assist you, please provide the following information:
- Which firewall model do you need this routing function for?
- What is your specific use case or business requirement for this routing function?
- You mentioned that some models already support this function. Could you:
- Specify which model(s)
- Share a screenshot of the existing configuration
Zyxel_Judy
0 -
Its the FLEX200 H and on a early version of the firmware it was possible see case #456511
The specific use case was that it worked and I used it and now have had to set it up another way which means a extra port was needed
It was done on a Zywall 110 which was replaced for more testing with FLEX200 H
0 -
Hi @PeterUK ,
Thank you for your interest. We are still evaluating this feature. We will announce it in our Firewall News & Release section if it becomes available in the future.
Zyxel_Judy
0
Categories
- All Categories
- 434 Beta Program
- 2.7K Nebula
- 174 Nebula Ideas
- 117 Nebula Status and Incidents
- 6.1K Security
- 418 USG FLEX H Series
- 297 Security Ideas
- 1.6K Switch
- 78 Switch Ideas
- 1.2K Wireless
- 43 Wireless Ideas
- 6.7K Consumer Product
- 269 Service & License
- 416 News and Release
- 87 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4.1K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 84 About Community
- 87 Security Highlight