USG FLEX 500 and Two SUBNET Interface

Smartmob

I have a zyxel USG FLEX 500 firewall with lan1 interface (192.168.0.230 - DHCP managed by Active Directory) lan2 interface (192.168.33.230 - DHCP Disabled).
Any machine I set in the second subnet can only communicate with the firewall and has no internet.
What configuration did I forget?

PeterUK

If your setting up a device with static IP on LAN2 for it to get to the internet you need to set the gateway and DNS both can be to the LAN2 interface gateway.

If ping to 1.1.1.1 works but not DNS you need to have a firewall rule from LAN2 to zywall or if DNS works but timeout to 1.1.1.1 you need from LAN2 to WAN

Smartmob

If I set the network card like this:

I have no network or internet, I do not understand what it is that can block.

I also tried setting a routing but no luck

PeterUK

Is "Enable IP/MAC Binding and DHCP Enforcement" checked for LAN2?

Smartmob

https://community.zyxel.com/en/discussion/comment/73806#Comment_73806

Nope

PeterUK

make routeing rule

incoming LAN2

next hop WAN

check your on the right port and zone is set to LAN2