DAI IP Source Guard stopped showing as working on V4.50(AAND.3)

PeterUK
PeterUK Posts: 3,326  Guru Member
100 Answers 2500 Comments Friend Collector Seventh Anniversary
edited August 2022 in Switch

I was on V4.50(AAND.2) and all was fine I could see the binding IP lease time but with V4.50(AAND.3) everything works but no show for binding IP leases. So is the setup i had working but nothing shows in IP Source Guard?

Accepted Solution

All Replies

  • Zyxel_Derrick
    Zyxel_Derrick Posts: 126  Zyxel Employee
    5 Answers First Comment Friend Collector First Anniversary
    edited July 2019

    Hi @PeterUK


    Welcome to Zyxel community

    May I know the no show for binding IP leases refers to the web GUI display?

    After upgrading the firmware, the binding IP lease time disappear on web GUI, am I correct?

    Also, may I know the binding IP is static or DHCP?

    Thanks


    Zyxel_Derrick

  • PeterUK
    PeterUK Posts: 3,326  Guru Member
    100 Answers 2500 Comments Friend Collector Seventh Anniversary

    Yes the binding IP lease time disappear on web GUI normally seen in Advanced Application > IP Source Guard > Source Guard Setup and for DHCP all the setup for Source Guard is their for like VLAN 50 and Trusted port.


  • Zyxel_Derrick
    Zyxel_Derrick Posts: 126  Zyxel Employee
    5 Answers First Comment Friend Collector First Anniversary

    Hi @PeterUK


    Thanks for your information

    We have found the issue and is working on it

    If there is any update will let you know asap

    Thanks


    Best regards,

    Zyxel_Derrick

  • PeterUK
    PeterUK Posts: 3,326  Guru Member
    100 Answers 2500 Comments Friend Collector Seventh Anniversary

    Hi the datecode firmware seems to be working Source Guard display is now showing.

    Thanks