UDP port 4500 sometime get blocked when allowed over bridge V2
So still happing this problem turns out was not the LAG bridge setup as I now have two port bridge on VPN300 but the only way to fix is to clear the NATT session in this case from 82.132.220.254 which UDP 4500 comes in on one interface of the bridge and does not send out the other interface until session is cleared then it flows. The problem happens randomly when IP changes normally.
So I'm hope there are some settings by SSH I can change to maybe help the problem? As I tried setting UDP timeout to 30 seconds thinking if the VPN fails it waits before retying so that the session would clear but it didn't work
Cut down layout
0
Categories
- All Categories
- 429 Beta Program
- 2.6K Nebula
- 163 Nebula Ideas
- 112 Nebula Status and Incidents
- 6K Security
- 350 USG FLEX H Series
- 291 Security Ideas
- 1.5K Switch
- 78 Switch Ideas
- 1.2K Wireless
- 42 Wireless Ideas
- 6.6K Consumer Product
- 261 Service & License
- 407 News and Release
- 87 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 3.8K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 82 Security Highlight