XGS2220 VPLS routing

oliversolman

Hi all, we are trying to route XGS switch which is 10.7.1.7 0.0.0.0/0.0.0.0 to 10.7.1.4 but fail on adding route. We where told we should be able to do this but when we try to add route is tells us its invalid syntax. Does anyone has any suggestions? We trierd Nebula and standalone with no luck.

Zyxel_Judy

Hi @oliversolman ,

To better assist you, please provide the following information:

1. What is the VPLS routing configuration in this case?
2. What is the intended purpose of this configuration?
3. We realize that 10.7.1.7 and 10.7.1.4 are on the same subnet, so there is no need to add a route to allow the traffic to flow. So, what are the source and destination IP addresses, devices, and the positions they are placed?
4. How did you configure Standalone mode? Please include screenshots of your configuration and any invalid syntax messages.