wifi and captive portal
Hello,
I just recently purchased NWA130BE to use it as access point.
I have Pfsense as main router and switch for the vLan and Poe+
Everything connected and setup including the wifi names vlan and works perfectly for 2 subnet
The issue with my Guest network as i am using captive portal configured on pfsense to login and that's is not working as it,s trying to access the subnet to open portal.domain.com
Any advice how to get it working
0
All Replies
-
Hi @mad_4u ,
To better support you, please share the following information:
- Is your network topology: Pfsense → Switch → NWA130BE - - - wireless clients?
- Is your NWA130BE managed by Nebula cloud or in standalone mode? And the firmware version?
- Did you configure the Guest network SSID through the NWA130BE's local GUI?
- Are you experiencing this issue: wireless clients (laptops, phones, etc.) connect to the NWA130BE's Guest network SSID and can access the Internet directly without going through the captive portal configured on your Pfsense router?
- Does this same issue occur with other SSIDs on the NWA130BE or with wired devices on your network?
Zyxel_Judy
0
Categories
- All Categories
- 434 Beta Program
- 2.7K Nebula
- 172 Nebula Ideas
- 117 Nebula Status and Incidents
- 6.1K Security
- 407 USG FLEX H Series
- 297 Security Ideas
- 1.6K Switch
- 78 Switch Ideas
- 1.2K Wireless
- 43 Wireless Ideas
- 6.7K Consumer Product
- 268 Service & License
- 416 News and Release
- 87 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 82 About Community
- 83 Security Highlight