How to enable flow control via command line in Nebula mode?
Zyxel_Melen
Posts: 4,027
Guru Member
Guru Member
Please access the switch and enter these commands:
#configure
(configure)# interface port-channel XX
(config-interface)# flow-control
(config-interface)# exit
(configure)# exit
#write memory
Note: Only the model that support CLI configuration support this FAQ. Like XS3800, XGS2220, GS2220, XMG/XS1930(with L3 license)
Zyxel Melen
0
Categories
- All Categories
- 439 Beta Program
- 2.8K Nebula
- 200 Nebula Ideas
- 126 Nebula Status and Incidents
- 6.3K Security
- 497 USG FLEX H Series
- 323 Security Ideas
- 1.6K Switch
- 83 Switch Ideas
- 1.3K Wireless
- 49 Wireless Ideas
- 6.8K Consumer Product
- 286 Service & License
- 457 News and Release
- 89 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4.3K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 95 Security Highlight