change rule via cli
Dear all,
my name is Heimo and this is my first question. I am not a Firewall specialist and so i changed a rule (webinterface from LAN) unintentionally from allow to deny and so I am not able to access the web gui. For this gui my knowledge is ok.
Does anybody know how to change a secure-policy of a FLEX-100 from deny to allow via cli?
Kind regards
Heimo
0
All Replies
-
Hi @Heimo
Please try to:
- Login to your firewall via SSH/Console.
- Use the command "show running-config" to identify this security policy. For example: "secure-policy 8".
- Use the command "configure terminal" to enter the configuration mode.
- Enter the security policy you found in step 2 to enter the editor mode for this policy.
- Use the command "no activate" to disable this policy.
- Remember to exit the configuration mode and enter write to save the changes.
Zyxel Melen0
Categories
- All Categories
- 435 Beta Program
- 2.7K Nebula
- 180 Nebula Ideas
- 120 Nebula Status and Incidents
- 6.1K Security
- 437 USG FLEX H Series
- 299 Security Ideas
- 1.6K Switch
- 80 Switch Ideas
- 1.2K Wireless
- 44 Wireless Ideas
- 6.7K Consumer Product
- 276 Service & License
- 431 News and Release
- 88 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4.2K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 83 About Community
- 89 Security Highlight