GS1900-8 with port 5 at VLAN1 - PORT 5-6-7 at VLAN 2-3-4

rainman70

Hi

I am not skilled on VLAN and TRUNK. I have to connect VLAN 1 on port 5 with a trunck to 3 VLANS . The purpose is to redirect a range of IP from VLAN 1 to VLAN2 , an new IP range from VLAN 1 to VLAN 3 and a new one range from VLAN1 to VLAN 4

Zyxel_Tina

Hi @rainman70,

Welcome to Zyxel Community!

We would like to better understand your intended application, especially this part:

The purpose is to redirect a range of IP from VLAN 1 to VLAN2, a new IP range from VLAN 1 to VLAN 3, and a new one range from VLAN1 to VLAN 4.

Could you please explain in more detail what you would like to achieve with this setup?

If your goal is to perform VLAN routing, please note that this cannot be done on the GS1900 series switch, since it is a Layer 2 device. To achieve inter-VLAN routing, you would need a Layer 3 switch, firewall, or router.

rainman70

Hi Tina

Glad to hear from you

I have a NODE RED linux platform running at 10.6.0.xxx .

I have to share this server network segment with 3 furthermore segments ( = VLAN )

Check below

VLAN 5 is for server 10.6.0.2 : PORT 4

VLAN 1 is at 192.168.1.100 for management : PORT5

VLAN 2 is at 172.26.200.xxx PORT 6

VLAN 3 is at 172.26.201.xxx PORT 7

VLAN 4 is at 172.26.202.xxx PORT 8

Regards

Diego

PeterUK

Without a layer 3 switch the subnets a routed by your router.

rainman70

Hi

Do you have a layer 3 model to suggest me ?

Regards

Diego

PeterUK

The XS1930-10 or XGS1935-28

So I take it you have a VLAN router with the subnets?

When setting up you have one default gateway the switch goes to you have subnet's on the XS1930-10 to ack as gateway's that your device point to for gateway so that VLAN traffic routes by switch and any other traffic for the internet routes by default gateway to your router.