USG60 - LAN1 and VLAN10 (LAN1)

Bogazki

Hello everyone
I need help.
USG60 equipment.

P1 - WAN1
P2 - WAN2
P3, P4 - LAN1
P5, P6 - LAN2

I need to use VLAN10 for SIP phones in LAN1 and use LAN1 for computers. The SIP server is in LAN1.

I created on the menu NETWORK - Interfaces - VLAN - VLAN10(Base LAN1).
On the switch to which the USG60 is connected, I configured a port for VLAN10 tagging. SIP phones receive addresses from the VLAN10 subnet. However, there is a problem with traffic between LAN1 and VLAN10. Pings are not working.
Even though routing between interfaces in the same zone should be enabled by default.

Bogazki

The problem has been resolved.
In the USG60, the VLAN10 settings specified DHCP relay to an external server. The error was in the external DHCP server settings: the default gateway address was incorrect.

PeterUK

If they are in the same zone and you don't have the default policy control rule from LAN1 to any you need to do a policy control rule from LAN1 to LAN1